道路机扫作业质量标准

Quality standards for road scanning

1、按规定的时间、路线作业。

In accordance with the prescribed time and route.

2、作业时，主刷落地高度一般降至刷苗稍压地面为宜，土箱调 整到进土的位置。

When doing homework, the main brush will fall to the ground level, which is suitable for the ground level. The soil case will be adjusted to the position of the earth.

3、按规定时速进行清扫作业并根据路面污染情况清扫时选用一 挡或二档，保洁时选用二挡或三挡。清扫时速不超过10 公里/小时。

To clean the work according to the regulation speed and to choose one block or two when cleaning according to the pollution condition of road surface, and when cleaning, two or three gear is chosen. Sweep no more than 10km/h.

4、司机要把扫尘装到指定容器内，并打扫干净，不得露天堆放。

4, the driver should pack the dust into the designated container and clean it up, not in the open air.

5、司机要到相关部门指定的地点及时加水卸土。

The driver will go to the designated location of the relevant department to add water and land.

6、作业时，做到不扬尘、不漏土，路沿石无尘土、无污物，达到 车走地净。

When the work is done, there is no dust, no dirt, no dirt, no dirt on the road, and the road is clean.